|
|
 |
USB Powered Xodus Programmer |
 |
USB Powered Xodus ProgrammerPublished by  DJB on 2003-10-31
Category: Modchip | Page Views: 2,647
Tutorial written by : myst1x
With this quick tutorial you can have your Xodus Programmer running off USB power in no time.
Tired of running out to get a new 9 volt battery in order to flash your Matrix or Chameleon or even Cheapmod? No worries, my friends. With this quick tutorial you can have your Xodus Programmer running off USB power in no time.
Required Items:
- Xodus Matrix/Chameleon Programmer
- USB cable
- 15w Soldering Iron
- Solder
- 5 minutes of your time
Optional Items:
- Electrical Tape
- Heat shrink tubing
First thing is first, cut open that USB cable and cut away any other wires other than the red and the black wires inside the cable. You may have to strip a little bit of housing off of the USB cable to get at these wires adequately. Now that you have those two wires out in the open, strip ‘em. Now, solder them to their designated points. You have 2 options. Both are illustrated below. You may have to shorten up your USB cable. Use the heat shrink/electrical tape to cover up where you shortened up the cable.
On top
Finally, route your cable with the electrical tape if you’d like along the back of the programmer. Or just leave it hanging. I’d suggest you tape it to the back of the programmer. Works like a charm!!!
|
|
|
Browse Tutorials |
|
| |
 | Latest News | |
| Popular Xbox Games | |
 Grand Theft Auto III
 Page Views: 2,246
Grand Theft Auto III is the third entry in the Grand Theft Auto series, following 1999's Grand Theft Auto 2. The game is the fifth instalment overall... |  | | More Xbox Games |
| |
HQ Network: 14,144 | 
Guests: 6552 | 
