Posted: Fri Mar 04, 2005 7:31 pm Post subject: Spider Chip Help
Ive just received my Spider v1.1
I followed the installation manual v1.1 for my xbox version 1.0
I successfully was able to power up the chip, and get both the lcd on the chip and switch working. I was unable, however to successfully load the spider bios screen. I have the "D" wire, in the correct hole as shown in the tutorial. Whenever I power up the box, however, the standard green animation occurs and brings me to the regular xbox hub...where do I go from here-is my chip defective?
I need help, thank you
RIP1982 Xbox-HQ Elite Member
Joined: May 14, 2004 Posts: 323 Location: Nasti Nati
Posted: Fri Mar 04, 2005 7:53 pm Post subject:
in most cases this is caused by the solder filled lpc holes (most common on xbox mobo versions 1.0-1.1)... you should remove the solder from the lpc holes via desolder braid or solder pump. i do remeber someone saying they just smushed the solder into the lpc holes allowing the chip to boot, but that isnt proper way to do it. _________________ [RIP Radio]
24-7 streaming internet radio
*works on windows pcs with IE or FF*
Yes, that makes sense.
I will try that.
Thank you so much for your reply.
Dark_Rebel Xbox-HQ Elite Member Xbox Version: All 1.0-1.6 Modded: Xecuter3 & Spiderchip
Joined: Nov 10, 2004 Posts: 347 Location: Belchertown, MA
Posted: Wed Mar 23, 2005 4:37 pm Post subject:
I just some small sharp tweezers and pole little holes into the plc holes. then when the chip goes is its as snug as a bug _________________ Blue Chaos
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum You cannot attach files in this forum You can download files in this forum
HQ Network: 8,533 | 
Guests: 1282 | 
Members: 1 
Forums 
