Posted: Wed May 29, 2019 7:31 pm Post subject: Cannot see G drive with xecuter3 mod
I have a 2tb origins image that i have written to a new 2tb hard disk. My original xbox console has a xecuter3 mod chip installed and is running bios 3294. When running hexen tools i can see the G drive and browse the files on it fine but when i boot xbmc i cannot see a g drive, only a f drive.
Any advise would be awesome.
Joined: Aug 13, 2018 Posts: 600 Location: United States
To use non-standard LBA48 partition configurations, you must use XBPartitioner v1.3 to format partitions 6 and 7 on a 2TB hard drive. Verify that 64KB cluster allocation is being used for both extended partitions 6 and 7..
For the X3 BIOS to recognized them properly, you have to enable the Use Saved Partition Table option in the X3ConfigLive Disk Tools settings.
1 - X3CL Select Disk Tools.jpg
Select Disk Tools -> Press A
2 - X3CL Disk Tool - New Hard Drive Upgrade.jpg
Select New Hard Drive Upgrade -> Press A
3 - X3CL - Use Saved Partition Table - Disabled.jpg
Select Use Saved Partition Table -> Press A
4 - X3CL Use Saved Partition Table - Enabled.jpg
Make sure Use Saved Partition Table = Enabled. If not, Press A again it toggles the value between Enabled and Disabled. Repeatedly Press B to return to top-level menu. Reboot.
All times are GMT |Page 1 of 1
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum You cannot attach files in this forum You can download files in this forum