Joined: Mar 02, 2005 Posts: 106 Location: Liverpool, UK
Posted: Wed May 04, 2005 12:45 am Post subject: IR Mod Install
Could anyone help me with this? iv bought the IR Mod from baldbouncer.co.uk but the install instructions are far too vague on his site and wfter much googleing i finally found an identical chip - reciever combo, but with different install instructions. my problem is that the new instructions appaer to be telling me to solder the pic chip topside directly to the legs of another chip already on the motherboard via six wires. no problem with this in theory (except the fear of scorching xbox components beyond use if i f it up) but surely there is an easier way,
has anybody else succesfully installed one of there or one like it wou could help me out? _________________ XBOX v1.4
Xecuter 3 (3108 Bios) {With X3CP}
IR Power Mod
EvoX Dash / Avalaunch
120 Gb WD Hdd
Green EL 'X'
12" UV & Blue Plasma Underlight
Blue Controller ports
12v 80mm Clear Fan
Stock eject with 50/50 mod
Decals from GCSkins
RIP1982 Xbox-HQ Elite Member
Joined: May 14, 2004 Posts: 323 Location: Nasti Nati
Posted: Wed May 04, 2005 2:02 am Post subject:
i use an ir mod in my box... im not sure which one you are using but here is a tut that should give you a good idea on what to do:
TheModGod
----------------------
http://www.themodgod.com _________________ Good Deals: Death@Hand, funkydopenloven, StaticMind, Slamscaper, PorscheXboxter
Bad Deals: None Yet
Pending Deals: Vanguard
thedude2004 Xbox-HQ Experienced
Xbox Version: Xbox v1.2 & 1.4 Modded: SID 2.0
Joined: Mar 02, 2005 Posts: 106 Location: Liverpool, UK
Posted: Fri May 06, 2005 2:16 pm Post subject:
the one modgod posted was the one i found on the bald bouncer site but i thought it was too vague so i wnt looking for another set of instuctions. the second one i found was the one posted by RIP1982 and the numbers on the chip seemed to match so i went ahead. after much painstaking soldering ended up with a xbox that would not turn on at all so i desoldered all the connections and ended up with an xbox that would not turn off! I realised that this must be that iv broken a connection from the control chip so the power signal was always "low" and thus "on" so i resoldered pin 18 on the cotroller and its back to normal now. Im about ready to give up on this, I dont know what im doing wrong and im not overly confident about soldering directly to a motherboard chip.
Anyone know when the official X3 IR is coming out? _________________ XBOX v1.4
Xecuter 3 (3108 Bios) {With X3CP}
IR Power Mod
EvoX Dash / Avalaunch
120 Gb WD Hdd
Green EL 'X'
12" UV & Blue Plasma Underlight
Blue Controller ports
12v 80mm Clear Fan
Stock eject with 50/50 mod
Decals from GCSkins
|
All times are GMT |Page 1 of 1
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum You cannot attach files in this forum You can download files in this forum